Products PRODESO HEAT membrane (uncoupling waterproofing membrane for electric heating)

PROGRESS PROFILE S.P.A.

PRODESO HEAT membrane (uncoupling waterproofing membrane for electric heating)

The Prodeso Heat membrane is a membrane made of polypropylene, with pseudo square pads equipped with interlocking locations to ensure the engagement of the heating electric wire, provided at the bottom with a polypropylene non-woven fabric which ensures bonding to the support. The membrane allows Prodeso Heat: - A flexible choice of the areas to be heated - Time savings during installation - The uncoupling desolidarisation - The steam vent - Waterproofing - The uniform distribution of the load - Small increase of 5.5 mm thickness. Thanks to de solidarizzanti / uncoupling / properties of the membrane, you can install tiles and even heated floors on media such as plywood, problematic screeds, etc. It 'also possible to eliminate the expansion joints in the screed and fractionation. The Prodeso Heat membrane can be installed over the entire surface as an uncoupling membrane de solidarizzante and waterproofing, and is part of Prodeso Heat System, a heating system with electric cables, innovative and patented uncoupling desolidarizznte, waterproofing that favors the steam vent. With this system it is possible to lay the membrane, the electric heating cables and the tiles on the same day. Compared to other systems, it reduces application time and adapted to the specific requirements of the case: the power cable can be laid in the fact of the membrane channels only where you want it and where it is recommended to have heat. If you combined with programmable thermostats, to plan and control the floor heating cycle, optimizing the thermal comfort and reducing operating costs. The heating times of the interior are much faster. Moreover, the product is easily recyclable, as they are easily separable from the other components of the flooring.

Note: All the information below was checked with advisor QualityNet support

Green Features #1

  • Recyclable Product Packaging

    done

Credits for LEED® System #4

LEED NC ITALIA 2009

EAc1 Ottimizzazione delle prestazioni energetiche

MRc2 Gestione dei rifiuti da costruzione

QIc4.1 Materiali basso emissivi: adesivi, primers, sigillanti, materiali cementizi e finiture per legno

QIc6.2 Controllo e gestione degli impianti: comfort termico

LEED NC 2009

EAc1 Optimize Energy Performance

MRc2 Construction Waste Management

IAQc4.1 Low-Emitting Materials—Adhesives and Sealants

IAQc6.2 Controllability of Systems—Thermal Comfort

LEED 2009 FOR COMMERCIAL INTERIOR

EAp2 Minimum Energy Performance

MRc2 Construction Waste Management

IAQc4.1 Low-Emitting Materials—Adhesives and Sealants

IAQc6.2 Controllability of Systems—Thermal Comfort

LEED FOR SCHOOLS 2009

EAc1 Optimize Energy Performance

MRc2 Construction Waste Management

IAQc4.1 Low-Emitting Materials - Adhesives & Sealants

IAQc6.2 Controllability of Systems—Thermal Comfort